RG Unicorn Gundam #1 - Shield

Build process of RG Unicorn Gundam Note #1, still a long way to go...😅

白色地獄製作製作筆記....漫長道路的開始
先來可變之盾，12種LED 光效，只可惜因為本身是透明紅框架，其他顏色難以清楚表現，不過原只期望製作紅框，因此還是由它罷。
12 x LED effect controlled by Attiny85 + RGB LED.  But Green/Blue effect are not really observable on transparent red frame...😓

Build Process

1. Overall Structure
   
2. Bore four 1mm ∅ holes around the frame (six here 😅, only four need)
   
3. 0402 SMD RGB LED
   
4. Installed on the frame
   
   
5. White LEDs on the edge (total 4)
   
6. Shield handle contact to its movable body by copper plate on both side
   
7. The Power source is located on both side of Unicorn Gundam Arm
   
   
   
   
8. LED effect controlled by Attiny85, change LED by soft switch
   
9. Dedicated for Shield control only, simple code and control mode change by soft switch